Corrosion Technologies RejeX® High Gloss Polymer Finish
SPACE AGE PROTECTION FOR YOUR CAR, TRUCK, BOAT, RV, AIRPLANE & MOTORCYCLE
RejeX is a thin-film polymer coating designed to provide a high-release protective finish for vehicles of all kinds. This very thin film less than a micron thick prevents stains and adhesion of common contaminants such as exhaust, bugs, oil, tree sap, bird droppings, road grime, brake dust, etc.
Nothing Sticks but the Shine!
It also makes graffiti easy to remove and can be applied to windshields to repel rain. It's easy to apply and produces a deep, lustrous shine that outlasts the most popular waxes by months.
RejeX contains none of the free silicone oils found in some other products that are known to contaminate paint and cause problems when repainting.
RejeX should be applied to a cool (less than 85° F) dry surface out of direct sunlight. If the surface is too hot, the coating will cure before it has properly bonded to the surface, and it wonﾒt perform up to its potential. RejeX is wiped on, allowed to dry to a haze for approximately 20 minutes, wiped off, then allowed to cure for 12 hours.
Curing is required to allow the monomers (polymer building blocks) that make up RejeX to attach to the surface being treated and to polymerize (crosslink) into a crystal-clear, impervious film. It is very important to allow RejeX to cure for 12 hours after the haze has been wiped off. If the coating is exposed to contamination such as oil, fuel, soot, water, cleaners, etc. before it has cured, the contaminants may interfere with the film, preventing the RejeX from achieving it's maximum performance and durability.
Rejex protects and beautifies painted metal, glass, acrylic, gel coat, fiberglass, glossy plastic and polished metal surfaces!
RejeX is not meant to be used on porous surfaces, highly oxidized painted surfaces, or to fill fine scratches. RejeX can be applied in multiple coats, allowing 8 hours curing time between coats for deeper color and greater depth of gloss. RejeX has a higher refractive index than waxes, so it produces richer, deeper looking colors and a lustrous long-lasting finish.
RejeX can be used over existing wax; however, the duration of protection will be reduced as the softer underlying wax degrades comparatively quickly. There is no reason to wax over RejeX. As we've already said, RejeX leaves a shinier, longer-lasting finish than wax and the wax can't adhere well to RejeX!
If a RejeX-treated surface needs repainting, normal paint preparation is all that's required. Abrasive cleaners, polishes, rubbing compounds or chemical paint strippers will remove the RejeX film.
- RejeX 12 oz
- RejeX 16 oz
- RejeX 1 Gallon
- RejeX 5 Gallon Pail (By special order only)